Zebra MC75 Guide de l'utilisateur télécharger pdf (Page 65)

Using the MC75 2 - 31

Figure 2-18

Linear Scanning

3. Press the scan button. Ensure the red scan beam covers the entire bar code. The Scan/Decode LED lights red

to indicate that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code

was decoded successfully.

Figure 2-19

Linear Scanner Aiming Pattern

Imager Scanning

1. Ensure that a scan-enabled application is loaded on the MC75.

2. Aim the scan window at the bar code.

Figure 2-20

Imager Scanning

3. Press the scan button. The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within

the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate that

scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was decoded

successfully. Note that when the MC75 is in Pick List Mode, the imager does not decode the bar code until the

crosshair touches the bar code.

Incorrect

Correct

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 201 202

Pas de commentaire

Zebra MC75 Guide de l'utilisateur Page 65