Zebra S600 Spécifications télécharger pdf (Page 63)

Zebra S400 & S600 User’s Guide 55

5HVHWWLQJ5LEERQ3DUDPHWHUV

If it is ever necessary to reset the ribbon parameters to the factory default

values, follow this procedure:

1. Turn off the printer.

2. Open the printhead and remove the ribbon.

3. Turn on the printer while pressing and holding the FEED, CANCEL,

and MODE buttons.

4. After the PRINTHEAD LED flashes, reload the ribbon.

5. Close the printhead.

NOTE: A label automatically prints, showing the ribbon sensor

profile.

6. To save, press the MODE button four times.

3ULQWHU'LDJQRVWLFV

3RZHU2Q6HOI7HVW

A Power-On Self Test (POST) is performed automatically each time the

printer is turned on. This test checks for proper initialization of various

electronic circuits and establishes starting parameters as those stored in the

printer’s memory. During this test sequence, the front panel lights turn on

and off to ensure proper operation.

At the end of this self test, only the POWER LED remains lit. If other

LEDs are also lit, refer to “Troubleshooting Tables” beginning on page 45.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 93 94

Pas de commentaire

Zebra S600 Spécifications Page 63