Zebra T402 Guide de l'utilisateur télécharger pdf (Page 50)

Replacing the Printhead

Refer to Figure 37.

1. Release the printhead by pulling the printhead release lever toward you.

2. Lift the printhead until you feel it “lock” into place. Be careful not to

force the printhead past this position!

3. Remove the screw that secures the printhead to the upper frame.

4. Remove the printhead wire harness connector from the receptacle.

5. Insert the printhead wire harness connector into the receptacle of the

new printhead. Make sure the connector is fully seated in the

receptacle.

6. Correctly position the printhead into the upper frame.

7. While holding the printhead in place, reinstall the screw that secures

the printhead to the upper frame.

Upper

Frame

Receptacle

Wire

Harness

Connector

Printhead

Screw

Figure 37

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 59 60

Pas de commentaire

Zebra T402 Guide de l'utilisateur Page 50