Zebra Z6M Manuel d'utilisateur télécharger pdf (Page 71)

Zebra Z4M/Z6M Printers User’s Guide 63

&OHDQLQJWKH9DOXH3HHORII0RGXOH

(Value peel-off option required)

Perform the following procedure if adhesive buildup begins to affect peel-off

performance.

Refer to Figure 26.

1. Open the printhead assembly.

2. Close the value peel assembly (if open) to prevent bending the tear-off/peel-off bar

during cleaning. Use a swab or cue tip soaked with a solvent to remove adhesive

from the tear-off/peel-off bar.

CAUTION: Apply minimum force when cleaning the tear-off/peel-off

bar! Excessive force can cause the tear-off/peel-off bar to bend, which

could have a negative effect on peel performance.

3. Open the value peel assembly by pivoting the module toward you.

4. Manually rotate the pinch roller and clean thoroughly with solvent and a swab.

NOTE: When cleaning the tear-off/peel-off bar or the pinch roller, remove

excess solvent with a pad to ensure the solvent has dried before printing.

5. Close the value peel assembly.

6. Close the printhead assembly.

Figure 26

Printhead Assembly

Pinch Roller

Value Peel Assembly

Tear-off/Peel-off Bar

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 111 112

Pas de commentaire

Zebra Z6M Manuel d'utilisateur Page 71