Zebra A300 Guide de l'utilisateur télécharger pdf (Page 22)

A set screw is located on top of the Printhead Carrier Assembly that can be

adjusted to control print quality. This adjustment is set at the factory and will

probably not need further adjusting. However, with different types and thick-

nesses of media, some adjustment may be necessary. To adjust the printhead

position, refer to Figure 5. Turn the set screw until optimum print quality is

obtained. Some trial and error may be necessary.

Figure 4. Adjusting for Different Media Widths

Figure 5. Adjusting the Printhead Position

547000r1 Page 17 Tuesday, March 25, 1997 11:38 AM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Pas de commentaire

Zebra A300 Guide de l'utilisateur Page 22