Zebra QL 220 Plus Guide de l'utilisateur télécharger pdf (Page 32)

QL Plus Series User Guide

If you have a printer equipped with the Kickstand option,

you must first remove the belt clip retainer as shown in Figure

15, retaining the two screws holding the retainer to the lower

cover. Arrange the communications cable in a broad loop as

detailed above, and capture it in the strain relief feature on the

bottom of the belt clip retainer. Then re-secure the belt clip

retainer to the bottom cover of the printer.

Refer to the Using the Accessories section for more information on the

use of thekickstand option

Figure 15: Communications Strain Relief with Kickstand option

1. Remove Belt Clip Retainer,

along with Belt Clip and

Kickstand.

2. Press communications

cable into strain relief feature

on bottom of Belt Clip

3. Reassemble Belt Clip to

bottom cover.

The kickstand is not shown in this view for clarity

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 84 85

Pas de commentaire

Zebra QL 220 Plus Guide de l'utilisateur Page 32