Zebra MtP400 Guide de l'utilisateur télécharger pdf (Page 14)

Printer Operation

Removing Printed Output

In most cases, the host application program will issue a Form Feed that will eject the paper so that all the

printed information is fed out of the printer and the receipt or label is ready to be torn off. If all the printing is

not yet out of the printer and the host has finished sending data to the printer, the paper may be positioned for

tearing by simply pressing the

Paper Feed Button.

To tear the paper, pull the paper against the tear bar at a slight angle as shown in Figure 7.

Figure 7 - Tearing Off Printed Output

Using the Magnetic Card Reader

The optional Magnetic Card Reader (MCR) is used by some applications to read information from credit cards,

drivers licenses, etc.

The MCR may be used in either the Host Request mode or the Always On mode. When used in the Host

Request mode, the host system sends a request to the DP-550 to enable the Magnetic Card Reader. “Swipe

Card Now” will be displayed and the

MCR Indicator will flash to indicate that the card may now be passed

through the MCR slot, or “swiped”. Refer to

Figure 8 for the card orientation.

When used in the Always On mode, the card may be swiped at any time and the data will be immediately sent

to the host system.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 72 73

Pas de commentaire

Zebra MtP400 Guide de l'utilisateur Page 14