Zebra PT40x Series Spécifications télécharger pdf (Page 54)

6HFWLRQ 0DLQWHQDQFH

10. Refer to Figure 4-5. Reinstall the power supply board and main logic board in the

front cover, ensuring the rubber bezel slides into the slots in the front cover.

11. Refer to Figure 4-8. Route all harnesses to avoid pinching and screw posts.

12. Refer top Figure 4-7. Ensure the battery access door is in the slot of the front cover

with the flat side facing in.

13. Replace the cover and shoulder strap.

14. Reinstall the battery. Connect a battery charger if necessary.

15. Perform the procedure Calibrate Ribbon Sensor on page 2-18.

16. load the media, and perform an auto-calibration.

Figure 4-8. Route Cable Harness

1RWH3HUIRUP6WHSRQD37[RQO\

Cable Clip

Ferrite

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 79 80

Pas de commentaire

Zebra PT40x Series Spécifications Page 54