Zebra 3742 Manuel de service télécharger pdf (Page 14)

Cleaning the Media Path

Keep the inside of your printer clean as needed, by using a brush, vacuum or air blower along the

media path (except the print head).

If a label jams inside the printer, remove the label and any adhesive residue immediately. Adhesive

may spread throughout the printer's media path if not completely removed. Many adhesive are

permanent and have short "set" times.

If the platen, dispenser bar, or serrated tear bear require cleaning, use 70% isopropyl alcohol

absorbed into a clean, lint-free cloth to wipe these surfaces. To turn the platen, use your finger to

advance the platen gear.

If the cutter requires cleaning, turn the printer off. Use tweezers to remove the media. Never use

solutions or solvents to clean the blade. If necessary, turn the printer on and use the C programming

command to cycle the cutter several times to perform a self cleaning operation. See the EPL2

programmer's manual.

Before Loading Media

You must remove the outside length of media (that is, one, full revolution of labels and any liner).

When you remove this part of the media, you remove the oils, dust, and adhesivers that

contaminate it. Tape or adhesive holds the loose end and the outside length of media becomes

contaminated when handled or stored.

You must avoid dragging adhesive or dirty media between the print head and

platen. such an occurance damages the print head and is not covered under the

warranty. Using clean media prevents damage and reduces wear on the print

head and platen.

6 980357-001 Rev. A

MOVIE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Pas de commentaire

Zebra 3742 Manuel de service Page 14