Zebra TTPM2 Manuel de service télécharger pdf (Page 15)

October, 01 TTPM2 Operators’ Guide 15

4.4 Many encoding retries

 Bad stripe material on ticket.

 Wrong ticket thickness.

 The ticket material hooks onto something on its way into the printer

 Dirt buildup on feed rollers.

 Erroneously adjusted magnetic rollers.

4.5 Frequent paper jams

 The ticket material hooks onto something on its way into the printer

 Ticket material too wide (wider than 54.3 mm).

 Slipping ticket transport due to dirt buildup on rollers or drive belts.

 Worn of missing drive belts.

4.6 Striped tickets

 Ticket material without magnetic stripe.

 Magnetic stripe on the wrong side. Should be facing

downwards on the left side of the printer as seen from

the ticket exit. (In the center facing down on center

track printers.)

 The ticket material hooks onto something on its way into the printer

 Misadjusted rollers over the magnetic heads.

Take some tickets and put them on the lid of the printer. Load them into the printer and print tickets. If the problem now is

gone, the ticket path to the printer is the cause of the problem.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Zebra TTPM2 Manuel de service Page 15