Zebra 110Xi4 Guide de l'utilisateur télécharger pdf (Page 108)

Configuration

Standard Control Panel Parameters

108

P1009874-003 Xi4™/RXi4™ User Guide 4/30/13

Set Reprint Mode

When reprint mode is enabled, you can reprint the last label printed either

by issuing the ~PR ZPL command or by pressing MINUS (-) on the control

panel.

Default Value: DISABLED

Selections: ENABLED, DISABLED

To change the value shown:

1. Press PLUS (+) or MINUS (-) to toggle between the options.

See next column View Sensor Settings

These parameters are automatically set during the calibration procedure

and should be changed only by a qualified service technician. Refer to the

Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for

information on these parameters.

To skip these parameters:

1. Press NEXT/SAVE to skip each of the following parameters:

Table 8 • Printer Parameters (Sheet 20 of 22)

Language/Parameter

Action/Explanation

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 187 188

Pas de commentaire

Zebra 110Xi4 Guide de l'utilisateur Page 108