Zebra DA402 Guide de l'utilisateur télécharger pdf (Page 16)

2. Separate and hold open the media hangers (refer to Figure 9).

3. Place the media roll onto the media hangers, making sure it is tightly

wound(refertoFigure10).

4. Open the peel-off unit by pulling down on its textured top surface (refer

toFigure11).

5. Activate the peel-off unit by moving the peel-off switch to the left

(refertoFigure11inset).

NOTE: When not operating the printer in peel-off mode, always

deactivate the peel-off unit by moving the peel-off switch to the

right.

6. Remove approximately 6” (152 mm) of labels from the label backing.

Media

Hanger

Media

Hanger

Figure 9

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Zebra DA402 Guide de l'utilisateur Page 16