Zebra GX420d Guide de l'utilisateur télécharger pdf (Page 29)

Getting Started

Printing a Test (Printer Configuration) Label

6/4/08 GX420d User Guide 980611-001 Rev. B

Printing a Test (Printer Configuration) Label

Before you connect the printer to your computer, make sure that the printer is in proper

working order.

You can do this by printing a configuration label.

1. Make sure the media is properly loaded and the top cover of the printer is closed. Then,

turn the printer power on if you have not already done so. If the printer initializes with the

status light blinking green (pause mode), press the Feed button once to set the printer in

Ready (to print) mode. See the Troubleshooting on page 77 if the printer’s status light

does not turn solid green (Ready).

2. Press the Feed button two to three times to allow the printer to calibrate the printer for the

installed media. The printer may feed several labels during this process.

3. When the status light is solid green, press and hold the Feed button until the status light

flashes once.

4. Release the Feed button. A configuration label will print.

If you cannot get this label to print, refer to Getting Started on page 11.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 105 106

Pas de commentaire

Zebra GX420d Guide de l'utilisateur Page 29