Zebra LP2824 Plus Guide de l'utilisateur télécharger pdf (Page 24)

Getting Started

Attaching Power

980644-001 Rev. A LP 2824 Plus™ User Guide 4/1/09

Attaching Power

1. Make sure the printer’s power switch is in the OFF position (0).

2. Insert the AC power cord into the power supply.

3. Plug the other end of the cord into an appropriate AC electrical outlet. Note: The active

power light will go on if power is on at the AC outlet.

4. Insert the power supply’s power connector into the printer’s power receptacle.

Important • Set up your printer so that you can handle the power cord easily if needed. To

make certain the printer cannot carry electrical current, you must separate the power cord

from the power supply receptacle or AC electrical outlet.

Caution • Never operate the printer and power supply in an area where they can get wet.

Serious personal injury could result!

Power

Connector

Power Switch

Plug Varies

by Country

Active Power Light

Power

Receptacle

Power

Cord

Printer

Power

Supply

IEC 60320

C-5

Note • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C5

connector are used at all times. These power cords must bear the relevant certification mark of

the country in which the product is being used.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 97 98

Pas de commentaire

Zebra LP2824 Plus Guide de l'utilisateur Page 24