Zebra T5206R Manuel d'utilisateur télécharger pdf (Page 156)

156

Chapter 3 PRINTER CONTROL

Ptx Setup Parse

• Enable. Will parse and execute the PTX SETUP commands.

• Ignore. Will parse the PTX SETUP commands but not act on them.

• Disable. Will not parse the PTX SETUP commands so they will print out

as text.

The factory default is Enable.

PJL Control

• Enable. Will parse and execute the PJL commands.

• Disable. Will not parse the PJL commands; they will not print out as text.

The factory default is Enable.

Glob Mem Adjust

This menu allows you to adjust the ratio of global memory allocated to label

size versus PGL forms, fonts, and logos. For example, when using short

labels, you can allocate more memory to forms, fonts, and logos by increasing

the Glob Mem Adjust value.

The amount of installed DRAM is 32 (MB). The range is from 0 to 12160

KBytes and the default is 9120 KBytes.

NOTE: Due to the large amount of memory required for font support, the

global memory adjust option is not available for P7000 H-Series

printers.

Max Font Buffer

The maximum amount of DRAM allocated to store the global font information

of any resident and downloaded scalable font (e.g. Intellifont, TrueType).

Each font contains its own global font information that is required for all

character generation from that font. Some fonts may require more font buffer

memory than others to generate characters. Insufficient font buffer memory

causes characters to be missing on the page and prints blank. If a font needs

more memory for character generation, increase the Max Font Buffer value to

allow the printer to print the missing character.

The range is from 100 to 1800 Kbytes, and the factory default is 100 Kbytes.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 393 394

Pas de commentaire

Zebra T5206R Manuel d'utilisateur Page 156