Zebra Z4M Manuel d'utilisateur télécharger pdf (Page 56)

48 Zebra Z4M Printer User’s Guide

Display Shows Action/Explanation

NETWORK ID

Setting Network ID Press the DECREMENT (-) key to move to the next

digit position, press the INCREMENT (+) key to increase the value of the digit.

Default: 000

Range: 000 - 999

Network ID is used to assign a unique number to a printer used in an

RS-422/RS-485 network. This gives the host the means to address a specific

printer. If the printer is used in a network, you must select a network ID

number. This does not affect TCP/IP or IPX networks.

COMMUNICATIONS

Setting Communications Mode Press the INCREMENT (+) or

DECREMENT (-) key to display other choices.

Default: Normal mode

Selections: Normal mode, diagnostics

The communication diagnostics mode is a troubleshooting tool for checking

the interconnection between the printer and the host. When “diagnostics” is

selected, all data sent from the host to the printer will be printed as straight

ASCII hex characters. The printer prints all characters received including

control codes, like CR (carriage return). A sample printout is shown in

Figure 32 on page 77.

NOTES on diagnostic printouts:

• An FE indicates a framing error.

• An OE indicates an overrun error.

• A PE indicates a parity error.

• An NE indicates noise.

For any errors, check that your communication parameters are correct. Set

the print width equal to or less than the label width used for the test. See

page 42 for more information.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 101 102

Pas de commentaire

Zebra Z4M Manuel d'utilisateur Page 56