Zebra MtP400 Manuel de l'opérateur télécharger pdf (Page 60)

Specifications

Black Mark Position

The vertical position of a Black Mark is dependent on the application program that will be used to search for

and print relative to the mark. The following diagram shows the optimum position when seeking the Black

Mark at the beginning of a print job and will require little, if any, reverse paper motion. (Note that reverse

paper motion in MtP400 SL models is not supported.)

The Black Mark must be printed on the front side of the paper for the MtP400 and MtP400 SL models. It may

optionally be printed on the back side of the paper for use with the MtP400 LP models

0.7092”

0.15”

Tear edge.

Front (thermal printed) side of form.

Black Mark should span width of paper for

best results.

Figure 14 - Black Mark Position

Gap Sensing Specifications

Gap Sensing is only available for MtP400 LP models. The minimum gap between labels is 0.125” (3.2mm).

1 2 ... 55 56 57 58 59 60 61 62 63 64 65

Pas de commentaire

Zebra MtP400 Manuel de l'opérateur Page 60