Zebra MtP400 Manuel de l'opérateur télécharger pdf (Page 9)

Getting Started

Battery Installation and Charging

Note: You must charge the battery for at least 2½ hours prior to the first use.

The battery for your MtP400 printer is shipped in an “uncharged” state. The battery must be charged using the

following instructions prior to using the printer for the first time. Maximum battery capacity is not reached

until after completing a minimum of three complete charge and discharge cycles.

Please refer to

Figure 1 and insert the battery by sliding it into the battery compartment until the release lever on

the battery “snaps” into place.

Figure 1 - Battery Installation and Power Connector

Release Leve

Power Connecto

Connect an optional power supply to the appropriate input source, and then connect the output of the power

supply to the printer’s Power Connector. The

Battery Indicator will turn on and remain on until the battery is

fully charged. This may take up to 2½ hours.

Caution: Use only Printek power supplies designed specifically for your MtP400 printer. Using a different

power supply may cause damage to the printer and will not be covered by the printer’s warranty.

Printek power supplies are available for use with 100-240VAC/50-60Hz and for12/24VDC vehicle

applications.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 64 65

Pas de commentaire

Zebra MtP400 Manuel de l'opérateur Page 9