Zebra MtP400 Manuel de l'opérateur télécharger pdf (Page 38)

Printer Configuration

Print Promotion

Print Promo

Possible Values: No*, Yes

This feature is only available in firmware version 2.8 or later.

When set to “Yes” this feature causes a previously stored graphic image with an ID value of “$” to be printed at

the end of each print job.

This feature may be used to print a special logo or graphic image of a special sales promotion or other event,

that also needs to be enabled/disabled by the user in the field.

Note: In firmware version 2.9 and later, multiple graphic images may be stored with the ID values of “!”,

“@”, “#”, “$”, “%”, “^”, “&”, “*”, “(“, and/or “)”. In this case, the printer will automatically cycle

through each of these images printing one at the end of each print job.

Please refer to the MtP Series & FieldPro Programmer’s Manual for more information on storing graphics and

logos.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 64 65

Pas de commentaire

Zebra MtP400 Manuel de l'opérateur Page 38