Zebra TTPM3 Spécifications télécharger pdf (Page 102)

Specifications

Document Stock

101

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

If a ticket is perforated, for stub separation for example, the perforation shall not infringe on

the magnetic track to prevent interference with magnetically encoded data.

Figure 18 • Position of the magnetic stripe.

Ticket Dimensions and Perforation

Remember these measurements when ordering tickets to be sure that they work in any ISO

7810 compliant equipment.

Track 1

Track 2

Track 3

Center Track

Track widths:

Tracks 1, 2, and 3: 3.1 mm

Center track: 7 mm



Transport

direction

Ticket viewed from bottom (magnetic stripe side)

7.06 mm

10.36 mm

13.92 mm

Note • ISO No. 7810 says that “all points on the edges of the card in the finished state, except

for the rounded corners, shall fall between two concentric, similarly aligned rectangles which

are dimensioned as follows:

- Outer rectangle: width 85.72 mm, height 54.03 mm

- Inner rectangle: width 85.47 mm, height 53.92 mm”

Stock format Fanfold gapped or non-gapped consecutive form tickets.

Note • On request, versions for roll paper can be built.

Requires testing with customer paper.

Sheet-cut (single) tickets for manual or dispenser loading.

Perforation cut direction Perforation and cutting of ticket material must be done from the

thermally sensitive side of the paper.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 111 112

Pas de commentaire

Zebra TTPM3 Spécifications Page 102