Zebra Eltron Card Printer Manuel d'utilisateur télécharger pdf (Page 18)

980261-001 Rev. B

C - CARD THICKNESS CONTROL LEVER

This item is operated by the user to prevent more than one card feeding into

the printer at the same time and causing a jam.

Open Cover, and adjust lever to correct

position. Repeat for different card thickness.

(Factory setting is for 30mil (0.762mm) card

thickness. See diagram below:

D - CARD OUTPUT HOPPER

For collecting printed cards.

Install Card Output Hopper onto printer by

hooking over button edge of card exit aperture.

Card Thickness:

A - 60mil (1.524mm) to 50mil (1.27mm)

B - 40mil (1.016mm)

C - 30mil (0.762mm)

D - 20mil (0.508mm)

E* - Less than 20mil (0.508mm)

* Start at lowest position and move lever

up to match card thickness.

For other card thickness, start lever at

lowest position and move up until cards

feed.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Pas de commentaire

Zebra Eltron Card Printer Manuel d'utilisateur Page 18