Zebra PrintServer Manuel d'utilisateur télécharger pdf (Page 54)

Getting Started

Assigning an IP Address

PrintServer II User and Reference Guide 43

Gleaning: To use this method, complete these steps:

A method where the print server uses the IP Address of the first ping packet that is sent

to its Hardware Address.

1. Add an entry to the ARP table that assigns an IP address to an Ethernet (Hardware)

address.

The syntax for this command is: arp -s " temporary ipaddress of

print server" "MAC Address (print server hardware

address) "

2. Power cycle the printer.

3. As the printer reboots, begin a continuous ping to the address assigned previously.

4. When the

PSII begins to respond, stop the ping activity.

In Windows, Ctrl + C, halts the pinging.

5. Telnet to the PSII and assign the appropriate IP address, subnet mask and gateway

if applicable.

6. Once this is complete, reset the PSII.

Example • You would type: arp -s 10.3.50.59 00-40-68-1D-B9-86

Note • Most UNIX systems use a continuous ping.

To use a continuous ping from a Windows host you must issue the

command: ping -t "ipaddress".

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 156 157

Pas de commentaire

Zebra PrintServer Manuel d'utilisateur Page 54