Zebra Wireless Print Server Guide de l'utilisateur télécharger pdf (Page 29)

Wireless Status and Settings

View or Change Control Panel Parameters for the Wireless Print Server

9/29/05 Wireless Print Server User Guide 13422L-002 Rev. B

View or Change Control Panel Parameters for the

Wireless Print Server

The control panel parameters are somewhat different for the S4M printer as opposed to other

Zebra printers. For the S4M printer, see Parameters for the S4M Printer on page 24.

Parameters for Zebra Printers Other Than the S4M

Table 3 shows the wireless parameters that may be viewed or modified through the printer’s

control panel. Some of the parameters can be password-protected by a wireless password. By

default, the Wireless Print Server runs in an “unprotected” mode (password set to 0000),

which means that you do not need to enter a wireless password through the control panel to

view or modify wireless settings. To set a wireless password (not the same as the general

printer password), use the

^WP ZPL command.

Note • Refer to the user guide for your printer for specific instructions on how to use the

control panel controls.

Table 3 • Control Panel Parameters for the ZebraNet Wireless Print Server

(printers other than the S4M)

Parameter

Function

LIST NETWORK This selection is used to print a network configuration label (see Figure 11

on page 20).

LOAD LAN FROM?

This parameter, which serves the same function as the ^NP ZPL command,

specifies whether to use the printer’s or the print server’s IP settings at

bootup.

Accepted Values: PRINTER, PRINTSERVER

Default Value: PRINTER

WIRED PS CHECK?

Check for a Wired Print Server at Bootup

This parameter, which serves the same function as the

^NB ZPL

command, tells the printer whether to search for a wired print server at

bootup.

Accepted Values: YES, NO

Default Value: NO

1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the

print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to

address 192.168.254.254.

2 Appears only when the ZebraNet Wireless Print Server is installed.

3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the

card supports LEAP.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 93 94

Commentaires sur ces manuels

Pas de commentaire

Zebra Wireless Print Server Guide de l'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs d'impression Zebra Wireless Print Server