Zebra Z4M Manuel d'utilisateur télécharger pdf (Page 47)

Leaving the Setup Mode

You can leave the program mode at any time by pressing the SETUP/EXIT key. The

“SAVE CHANGES” display will appear. There are five choices, described below.

Pressing the INCREMENT (+) or DECREMENT (-) key displays other choices and

pressing the SELECT key selects the displayed choice.

PERMANENT -- Permanently saves the changes. Values are stored in the printer

even when power is turned off.

TEMPORARY -- Saves the changes until changed again or until power is turned

off.

CANCEL -- Cancels all changes since pressing the SETUP/EXIT key except the

darkness and tear-off settings (if they were changed).

LOAD DEFAULTS -- Loads factory defaults.

LOAD LAST SAVE -- Loads values from the last permanent save.

Zebra Z4M Printer User’s Guide 39

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 101 102

Pas de commentaire

Zebra Z4M Manuel d'utilisateur Page 47