Zebra Z4M Manuel d'utilisateur télécharger pdf (Page 70)

Printhead Pressure Adjustment

This adjustment may be necessary if printing is too light on one side or if thick media

is used.

Refer to Figure 27.

The pressure adjustment dials each have four possible settings designated by blocks of

increasing size embossed on the print mechanism. The smallest block (fully

counterclockwise) is considered “position 1” and the largest block (fully clockwise) is

considered “position 4.”

The following table will help you to select the initial dial settings for your media.

NOTE: Some media types require higher pressure to print well. For

these media, increase both dials one position. If the media tends to

shift to the left while printing, increase the right dial setting one

position or decrease the left dial setting one position. If the media

tends to shift to the right while printing, increase the left dial setting

one position or decrease the right dial setting one position.

62 Zebra Z4M Printer User’s Guide

Media Width Left Dial Right Dial

1” (25.4 mm) 3 1

2” (51 mm) 4 1

3” (76 mm) 3 2

3.5” and up

(89 mm and up)

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 101 102

Pas de commentaire

Zebra Z4M Manuel d'utilisateur Page 70