Zebra Z4Mplus Manuel d'utilisateur télécharger pdf (Page 93)

Configuration

Configuration and Calibration Sequence

Z4Mplus and Z6Mplus User Guide 63

MEDIA TYPE Press SELECT to make change.

Setting Media Type: Press PLUS (+) or MINUS (–) to

display other choices.

Default: Non-Continuous

Selections: Non-continuous, Continuous

Press SELECT to accept the change.

This parameter tells the printer the type of media you are

using. Selecting continuous media requires that you include

a label length instruction in your label format (^LLxxxx if

you are using ZPL or ZPL II).

When non-continuous media is selected, the printer feeds

media to calculate label length (the distance between two

detections of the inter-label gap, webbing, or alignment

notch or hole).

SENSOR TYPE Press SELECT to make change.

Setting the Sensor Type: Press PLUS (+) or MINUS (–) to

display other choices.

Default: Web

Selections: Web, mark

Press SELECT to accept the change.

This parameter tells the printer whether you are using media

with a web (gap or space between labels, notch, or hole) to

indicate the separation between labels or if you are using

media with a black mark printed on the back. If your media

does not have black marks on the back, leave your printer at

the default setting (web).

Display Shows Action/Explanation

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 177 178

Pas de commentaire

Zebra Z4Mplus Manuel d'utilisateur Page 93