Zebra PA400 Manuel d'utilisateur télécharger pdf (Page 19)

Peel-Off Mode

NOTES: Your authorized Zebra reseller can recommend the

correct ribbon and peel-off media for your application.

If ribbon is loaded (PT400 only), remove the ribbon cartridge

before loading the media.

1.RefertoFigure4.Raisethemediaaccessdoorbyliftingatthenotch

until it unhooks from the top cover.

2.RefertoFigure5.Swingthemediaaccessdooropentoexposethe

media compartment.

3. Pivot the top cover to reveal the printhead.

4. Lift the printhead until you feel it “lock” into place. Use caution not to

force the printhead past this position!

WARNING: NEVER touch the thermal print elements on the

underside of the printhead. Under certain conditions, they

can be very hot! Also, dirt or moisture from your hands can

damage the printhead!

5.RefertoFigures5and6.Removeapproximately6”(152.4mm)of

labels from the media roll. Then, thread the media into the printer until

it extends approximately 1” (25.4 mm) past the printhead.

6. Separate and hold open the media hangers.

7. Place the media roll onto the media hangers, making sure it is tightly

wound.

8. Release the media hangers to lock the media into the correct position.

Ensure that the media is threaded under both media guides.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

Pas de commentaire

Zebra PA400 Manuel d'utilisateur Page 19