Zebra PA400 Manuel d'utilisateur télécharger pdf (Page 36)

Calibration

Auto Calibration

NOTE: The printer will not auto calibrate when you are using

pre-printed labels or pre-printed label backing. If you are using

thistypeofmedia,see“ManualCalibration.”

By default, this printer automatically sets the sensor levels for, and

determines the length of, the label you are using. To auto calibrate:

1.Loadthemediaaccordingtotheinstructionsin“LoadingtheMedia”in

Getting Ready to Print.

2.TurnontheprinterorpresstheFeedbuttoniftheprinterisalreadyon.

3. Some blank labels will feed, completing auto calibration.

4.IftheErrorLEDbeginsflashing,referto“ManualCalibration.”

Hints:

• Auto calibration only works when you are using non-continuous media

(a gap, notch, or black mark separates each label).

•

When auto calibration is selected, it occurs when the printer is turned on

(if the printhead has been opened), whenever an error is cleared, or if the

battery (or other power source) has been removed.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 57 58

Pas de commentaire

Zebra PA400 Manuel d'utilisateur Page 36