Zebra PA400 Manuel d'utilisateur Page 44

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 58
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 43
7. The battery is under voltage (level 2).
The battery may not have enough power to print the next label and can
reset the printer, losing formats in the printer. Plug the battery charger
into the printer (you don’t have to turn off the printer to do this). After
the battery is charged, press the Feed button.
8. FLASH memory is not programmed.
Return the printer to an authorized Zebra reseller.
Print Quality Problems
No print on the label.
If you aren’t using ribbon, make sure the correct media (direct thermal)
is loaded. Try this: Quickly rub your nail or a blunt object over the
label surface. If it doesn’t produce dark marks, the wrong media
(thermal transfer) is loaded.
Are the media and ribbon loaded correctly? Follow the instructions in
“LoadingtheMediaand“LoadingtheRibboninGettingReadyto
Print.
Youmaybetryingtousetheprinteroutsideofitsenvironmentallimits.
The correct operating temperature range for this printer is between 32° F
and 104° F(0° to 40° C).
The printed image doesn’t look right.
The printhead is dirty. Clean the printhead according to the instructions
inPreventiveMaintenance.
Printheadpressureneedstobeadjusted.Followthestepsin“Adjusting
thePrintheadPressureinGettingReadytoPrint.
Theprintdarknessneedstobeadjusted.See“AdjustingthePrint
DarknessinGettingReadytoPrint.
The print mode may be incompatible with the media you are using. If
your printer is set for thermal transfer mode, you must use thermal
transfer, rather than direct thermal, media and a ribbon cartridge.
The media being used is incompatible with the printer. Be sure to use
the Zebra-recommended media for your application.
Batteryvoltageislow.See“ChargingtheBatteryinGettingReadyto
Print.
35
Vue de la page 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 57 58

Commentaires sur ces manuels

Pas de commentaire