Zebra 105Se Spécifications télécharger pdf (Page 16)

8Zebra S-Series User’s Guide

6WRUDJHDQG5HVKLSSLQJ

If you are not placing the printer into operation immediately, repackage it

using the original packing materials. The S-Series Printer may be stored

under the following conditions:

• Temperature: –40° to +158° F (–40° to +70° C)

• Relative humidity: 20% to 85% non-condensing

Should it become necessary to ship your printer, remove any ribbon and

paper roll from the supply spools, otherwise damage to the printer could

result. Carefully pack the printer in a suitable container to avoid damage

during transit. Whenever possible, use the original container and

packaging material from the factory. If you use a different container, a

procedure similar to the original factory packaging should be followed.

&$87,21'RQRWSDFNDJHWKHSULQWHULQDULJLGFRQWDLQHU

ZLWKRXWXWLOL]LQJVKRFNPRXQWVRUVKRFNDEVRUELQJSDFNLQJ

PDWHULDO$ULJLGFRQWDLQHUDOORZVVKRFNRQWKHRXWVLGHWREH

WUDQVPLWWHGXQGDPSHGWRWKHXQLWZKLFKPD\FDXVHGDPDJH

3RZHU&RQQHFWLRQ

$&9ROWDJH6HOHFWLRQ3URFHGXUH

The S-Series Printer’s AC voltage may be set for either 115 VAC or 230

VAC operation. To match the printer’s power entry selection to the

available power source, refer to Figure 1 and follow the procedure outlined

below:

1. Locate the AC power area at the rear of the printer.

2. Using a small flatblade screwdriver or similar tool, move the voltage

selection switch to the 115 V or 230 V position as required. (The

initial position of the switch depends on how the printer was ordered.)

Make sure that the appropriate fuse is in place.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 109 110

Pas de commentaire

Zebra 105Se Spécifications Page 16