Zebra 105Se Spécifications télécharger pdf (Page 19)

Zebra S-Series User’s Guide 11

5LEERQ/RDGLQJ6H

Refer to Figure 4 throughout this procedure.

Note: When placing the ribbon roll on the ribbon supply spindle, make

sure that the core is pushed up against the stop on the ribbon

supply spindle and that the ribbon is aligned squarely with its

core. If this is not done, the ribbon may not cover the inside edge

of the printhead, exposing print elements to potentially damaging

contact with the media.

Do not load ribbon if the printer is to be used in the direct thermal

mode.

&$87,21'RQRW

XVHULEERQWKDWLVQDUURZHUWKDQWKHPHGLD,I

WKHSULQWKHDGLVQRWSURWHFWHGE\WKHVPRRWKEDFNLQJRIWKH

ULEERQH[FHVVLYHDEUDVLRQPD\FDXVHSUHPDWXUHSULQWKHDG

IDLOXUH

1. Align the segments of the ribbon supply spindle. See Figure 2.

Figure 2

2. Place the ribbon roll on the ribbon supply spindle.

3. Open the printhead by moving the handle to the OPEN position.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 109 110

Pas de commentaire

Zebra 105Se Spécifications Page 19