Zebra Z6Mplus Guide de l'utilisateur télécharger pdf (Page 64)

46 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004

Printer Operation

Adjust Printhead Pressure

See Figure 30. This adjustment may be necessary if printing is too light on one side or if thick

media is used.

Figure 30 • Printhead Pressure Adjustment Dials

The pressure adjustment dials for the Z4Mplus each have four possible settings designated by

blocks of increasing size embossed on the print mechanism. The smallest block (fully

counterclockwise) is considered position 1 and the largest block (fully clockwise) is

considered position 4. The same is true for the Z6Mplus, except it has seven positions.

Set Printhead Pressure

Depending on which printer you have, use Table 6 or Table 7 to select the initial dial settings

for your media.

Some media types require higher pressure to print well. For these media, increase both dials

one position. If the media tends to shift to the left while printing, increase the right dial setting

one position or decrease the left dial setting one position. If the media tends to shift to the right

while printing, increase the left dial setting one position or decrease the right dial setting one

position.

Pressure Adjustment Dials

Table 6 • Z4Mplus Printhead Pressure

Media Width Left Dial Right Dial

1 in. (25.4 mm)

2 in. (51 mm)

3 in. (76 mm)

3.5 in. and up (89 mm and up)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 141 142

Pas de commentaire

Zebra Z6Mplus Guide de l'utilisateur Page 64