Zebra S-500 Guide de l'utilisateur télécharger pdf (Page 19)

Ribbon Loading

Adjusting the Ribbon Supply Spindle

Ribbon Supply Spindle: Normal Position

In the Normal Position, the “ Dual-Tension” Ribbon Supply Spindle provides the

desired amount of ribbon back-tension for different ribbon widths.

To place the Spindle in the Normal Position, firmly pull the Spindle End-Cap until it

clicks into place, as shown in Figure 8.

Ribbon Supply Spindle: Low-Tension Position

Low-Tension Position is used in

limited applications

with ribbons wider than 2.4"

(60 mm) to provide lower ribbon back-tension. Low-Tension Position is only

recommended when normal tension hampers the ribbon movement.

To put the Spindle in the Low-Tension Position, firmly push the Spindle End-Cap until

it clicks into place, as shown in Figure 8.

Figure 8 Ribbon Supply Spindle Adjustment

Normal Position Low-Tension Position

Getting Started

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Pas de commentaire

Zebra S-500 Guide de l'utilisateur Page 19