Zebra S-500 Guide de l'utilisateur télécharger pdf (Page 52)

MODE Key Self Test

This self test places the printer in a

Communications Diagnostics Mode. In this mode,

the printer prints the ASCII characters and their

corresponding hexadecimal values for any data

received from the host computer. See Figure 30.

Note: Turn the power OFF to exit this self test.

FEED Key and PAUSE Key

If it is ever necessary to reset the printer

configuration to the factory default values, press

these two keys at the same time while turning the

Power ON. Permanently save these values in

memory by pressing the MODE key four (4)

times - MODE lights cycle ON then OFF. A Media

Calibration procedure must be performed any time Factory Default values are

saved. See Chapter 1.

Extended Printer Diagnostics

Extended diagnostic tests are available for the Zebra Stripe Printer. The Stripe

Maintenance Manual, Volume 1 (part # 44868L), provides information needed to

perform these additional tests.

Figure 30 MODE Key Self Test Printout

Troubleshooting and Diagnostics

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 79 80

Pas de commentaire

Zebra S-500 Guide de l'utilisateur Page 52