Zebra 10/100 Guide de l'utilisateur télécharger pdf (Page 39)

Getting Started

Assigning an IP Address

11/12/2009 10/100 Internal Print Server User Guide 14197L-005

Gleaning

A method by which the 10/100 Internal PS uses the IP address of the first ping packet that is

sent to its hardware address.

To use this method, complete these steps:

1. Add an entry to the ARP table that assigns an IP address to an Ethernet (hardware)

address.

The syntax for this command is:

arp -s "temporary ipaddress of print server" "MAC Address

(print server hardware address)" arp -s <temporary ip

address> <MAC Address>

2. Power cycle the printer.

3. As the printer reboots, begin a continuous ping to the address assigned previously.

4. When the 10/100 Internal PS begins to respond, stop the ping activity.

In Windows, Ctrl + C halts the pinging.

5. Telnet to the 10/100 Internal PS and assign the appropriate IP address, subnet mask, and

gateway, if applicable.

6. Once this is complete, reset the 10/100 Internal PS.

Note • Gleaning works only on local subnets at routers. It does not pass Address Resolution

Protocol (ARP) broadcasts.

Example • You would type:

arp -s 10.3.50.59 00-07-4d-68-1D-B9-86

Note • Most UNIX systems use a continuous ping.

To use a continuous ping from a Windows host, you must issue the command:

ping -t "ipaddress".

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 131 132

Pas de commentaire

Zebra 10/100 Guide de l'utilisateur Page 39