Zebra Z6Mplus Guide de l'utilisateur télécharger pdf (Page 26)

Printer Setup

Connect the Printer to a Power Source

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

Power Cord Specifications

Depending on how your printer was ordered, a power cord may or may not be included. If one

is not included or if the one included is not suitable for your requirements, refer to the

following guidelines:

• The overall cord length must be less than 9.8

ft. (3.0 m).

• The cord must be rated for at least 10 A, 250 V.

• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic

interference. The third wire in the power cord grounds the connection (Figure 6).

Figure 6 • Power Cord Specifications

Figure 7 • International Safety Organization Certifications

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use an

IEC 320 female connector and the appropriate region-specific, three-conductor grounded

plug configuration.

AC power plug for your country—This should bear

the certification mark of at least one of the known

international safety organizations (Figure 7).

3-conductor HAR cable or other cable approved for

your country.

IEC 320 connector—This should bear the

certification mark of at least one of the known

international safety organizations (Figure 7).

Length ≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 165 166

Pas de commentaire

Zebra Z6Mplus Guide de l'utilisateur Page 26