Zebra Z6Mplus Guide de l'utilisateur télécharger pdf (Page 71)

Operations

Adjust Printhead Pressure

1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A

Adjust Printhead Pressure

You may need to adjust printhead pressure if printing is too light on one side or if you use thick

media.

See Figure 25. The Z4Mplus pressure adjustment dials have four possible settings designated

by blocks of increasing size embossed on the print mechanism. The smallest block (fully

counterclockwise) is considered position 1, and the largest block (fully clockwise) is

considered position 4. For the Z6Mplus, the dials have seven settings instead of four.

Figure 25 • Printhead Pressure Adjustment Dials

To set printhead pressure, complete these steps:

1. Use Table 6 or Table 7 to select the initial dial settings for your media, depending on

which printer you have.

Outside dial

Inside dial

Table 6 • Z4Mplus Printhead Pressure

Media Width

Inside Dial Outside Dial

1 in. (25.4 mm)

2 in. (51 mm)

3 in. (76 mm)

3.5 in. and up (89 mm and up)

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 165 166

Pas de commentaire

Zebra Z6Mplus Guide de l'utilisateur Page 71