Zebra 160S Guide de l'utilisateur télécharger pdf (Page 55)

Bank 1 (For Serial Interface Printers Only)

The S-Series Printer, with the

RS-232 Serial Interface, uses

eight miniature switches located

on the rear of the printer, above

the Signal Interface Cable Con-

nector. The ON/OFF positions

of these switches establish some

of the Printer Configuration Pa-

rameters. Bank 1 switches must

be properly positioned to estab-

lish serial data communications

with the host computer. There-

after, the position of these

switches should not be changed.

Note: Parallel-interface

printers do not require

these configuration

parameters, therefore

they have no Bank 1

switches.

If these switches are in the

proper position to match the

communication configuration of

the host computer, and the

printer is not receiving data, re-

ferto“Interconnections”and

make sure the correct interface

cable is being used.

Note: The printer is fixed at 1

stop bit, so make sure

that your host device is

also set at 1 stop bit.

4-2 Zebra S-Series User’s Guide

Table 4.1

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 105 106

Pas de commentaire

Zebra 160S Guide de l'utilisateur Page 55