Zebra 160S Guide de l'utilisateur télécharger pdf (Page 61)

Data Specifications

When communicating via the serial data port (RS-232), the baud rate,

numberofdatabits,andtheparityareuser-selectable(see“Configura-

tionandCalibration”foracceptablesettingcombinations).Parityonly

applies to data transmitted by the printer, since it ignores the parity of re-

ceived data. The S-Series Printer is fixed at 1 stop bit, so make sure that your

host is also set at 1 stop bit.

When communicating via the parallel port, the previously mentioned

parameters are not considered.

RS-232 Serial Data Port

The connections for the standard interface are made through the DB25S

connector on the rear panel. For all RS-232 input and output signals, the

S-Series Printer follows both the Electronics Industries Association’s (EIA)

RS-232 and the Consultative Committee for International Telegraph and Tele-

phone (CCITT) V.24 standard signal level specifications.

5-2 Zebra S-Series User’s Guide

Table 5.1 RS-232 Pinouts

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 105 106

Pas de commentaire

Zebra 160S Guide de l'utilisateur Page 61