Zebra Eltron Card Printer Guide de l'utilisateur Page 100

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 112
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 99
Step 4. Adjust the Brightness Adjustment Screw by either loosening or tightening.
Remember the amount and direction of adjustment. If loosening, push the Head
Assembly until the adjustment screw again bears against the Print Head Yoke.
Step 5. Tighten the Head Fasteners in the sequence shown.
Step 6. Print another Test Card. Then compare the cards. Any improvement in
brightness signals a proper direction of adjustment. Conversely, any deterioration
in brightness indicates that the adjustment should have been in the opposite
direction or possibly that too great an adjustment placed the Print Head beyond
the optimum point.
Step 7. Repeat Steps three through six until an optimum brightness is achieved.
6-10 980264-001 Rev.B
CHAPTER 6
Figure 6-8. Image Brightness Adjustment.
Vue de la page 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 111 112

Commentaires sur ces manuels

Pas de commentaire