Zebra Eltron Card Printer Guide de l'utilisateur télécharger pdf (Page 101)

For an adjustment to make the Print Head parallel to the Platen Roller, continue as follows:

Step 8. Unlatch and raise the Print Head.

Step 9. Slightly loosen the Print Head fasteners shown in Figure 6-9. However, try to

maintain a tightness just sufficient to leave the Print Head position undisturbed.

Step 10. Examine the last Test Card printed to determine which side has a reduced

brightness. Then, slightly lower the corresponding side of the Print Head, and

tighten the screws.

Step 11. Perform a Peel Bar adjustment (see Section 6.3.4).

Step 12. Latch down the Print Head, and print another Test Card, Note the result of

the repositioning.

Step 13. Repeate Steps eight through 12 until a proper result is achieved.

980264-001 Rev. B 6-11

CHAPTER 6

Figure 6-9. Lower Print Head Fasteners.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 111 112

Pas de commentaire

Zebra Eltron Card Printer Guide de l'utilisateur Page 101