Zebra Eltron Card Printer Guide de l'utilisateur Page 70

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 112
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 69
5.2.8 Ribbon Sensor Removal
The four wires of the Ribbon Sensor connect to the Daughter Board. Refer to Figure 5-12, and
proceed as follows:
Step 1. Remove Rear Case, and disconnect the wires from the CPU Board, and if
installed, the Encoder Board (see Sections 5.2.1, 5.2.10, and 5.2.11).
Step 2. Remove the Rear Plate with attached circuit boards (see Section 5.2.11).
Step 3. Remove the single screw holding the Ribbon Sensor.
Step 4. Cut the Cable Ties holding the Ribbon Sensor wires.
Step 5. Unplug the Ribbon Sensor Connector from the Daughter Board.
Step 6. Remove the Ribbon Sensor while feeding the associated cable and connector
along the routing path.
5-14 980264-001 Rev.B
CHAPTER 5
Figure 5-12. Ribbon Sensor Removal.
Vue de la page 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 111 112

Commentaires sur ces manuels

Pas de commentaire