Zebra Eltron Card Printer Guide de l'utilisateur Page 77

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 112
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 76
5.2.15 Smart Card Interface Board Replacement (Option)
Units equipped for Smart Card Docking have the following components:
Smart Card Interface PWB
Smart Card Solenoid
Smart Card Contact Station
For Smart Card Interface removal, refer to Figure 5-19, and proceed as follows:
Step 1. Detach the Rear Case member (see Section 5.2.1).
Step 2. Disconnect the connectors to the Solenoid, CPU Board, and Contact Station.
Step 3. Remove the two DB-9 fasteners and the PWB. Note that excessive torque on
these fasteners during installation of a new PWB can produce damage. Try to
duplicate the torque required for removal when installing a new board.
980264-001 Rev. B 5-21
CHAPTER 5
Figure 5-19. Smart Card PWB
Vue de la page 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 111 112

Commentaires sur ces manuels

Pas de commentaire