Zebra EPL2 Manuel d'utilisateur Page 80

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 79
Loading ELP1 Font
Sets
1. Set the reconfigure the printer for Page
(EPL2) Mode. Send a EPL2 command to the
printer.
2. Send the EPL2 U command to the printer.
The printer will print a Dump Mode status re
-
port. If it prints a U, then the print is still in Line
Mode and steps 1 and 2 need to be repeated.
3. Download the EPL1 Font file
(LMFONT.BIN) with the Firmware
Downloader program. Change the file type pull
down menu to *.BIN files and load the font (and
the embedded command that activate the
EPL1 fonts).
4. Send the EPL2 OEPL1 (Set Line Mode)
command to the printer. Send a Line Mode
EPL? command to the printer to print a Dump
Mode printout. Verify that the printer is in Line
Mode and that the status line immediately be-
low the Option:” line has, at minimum, the
following: oEw, x, y, z
Cycle the printer power and repeat steps3&4if
the printer is not in Line Mode or the fonts (as
represented by oEw, x, y, z ) are not active and
loaded.
C-2 980353-001 Rev.B
Vue de la page 79
1 2 ... 75 76 77 78 79 80 81 82

Commentaires sur ces manuels

Pas de commentaire