Zebra EPL2 Manuel d'utilisateur Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
Deactivating the
EPL1 Fonts
1. 1. Set the reconfigure the printer for Page
(EPL2) Mode. Send a EPL2 command to the
printer.
2. Send the EPL2 U command to the printer.
The printer will print a Dump Mode status re
-
port. If it prints a U, then the print is still in Line
Mode and steps 1 and 2 need to be repeated.
3. Send the EPL2 o (Clear Special Mode Op
-
tions) command to the printer.
4. Send the EPL2 OEPL1 (Set Line Mode)
command to the printer. Send a Line Mode
EPL? command to the printer to print a Dump
Mode printout. Verify that the printer is in Line
Mode and that the status line immediately be
-
low the Option:” line has been cleared of the
following: oEw, x, y, z
Typically the last two lines will read:
Options:
04 07 10 << label sensor readings
Cycle the printer power and repeat steps3&4if
the printer is not in Line Mode or the fonts have
not been cleared.
980353-001 Rev.B C-3
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82

Commentaires sur ces manuels

Pas de commentaire