Zebra MZ series Manuel d'utilisateur télécharger pdf (Page 11)

Install the Replacement Cover

1. Align the replacement Media Cover

Assembly with the lower housing and

slide the pivot pin through the Media

Cover Assembly and into the lower

housing.

2. Drop the straight end of the media cover spring into the lower housing and

align the open coils of the spring on the lower housing to allow the pivot pin to

pass through it. Press the pivot pin completely into the lower housing.

3. Snap the upper housing back into position and re-secure all the attaching

screws.

• Sect.2-11 • RMAN-MZS-002 • MZ Series Repair Procedures

Media Cover

Spring

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Pas de commentaire

Zebra MZ series Manuel d'utilisateur Page 11