Zebra MZ series Manuel d'utilisateur télécharger pdf (Page 9)

Handling:

The use of an ESD wrist strap at a properly grounded workstation is required

when handling printed circuit boards or other sensitive electronic components.

The ESD strap prevents any electrostatic damage to occur while assembling

these components. The use of the ESD strap will be noted in the applicable

instructions.

This symbol indicates that the operator must wear a properly grounded ESD strap to perform the

repair procedure.

Storage

Replacement kits which are sensitive to ESD damage are supplied in static

resistant packaging. Always keep these parts in their original packaging until they

are to be installed.

STORAGE AND HANDLING

• Sect.2-9 • RMAN-MZS-002 • MZ Series Repair Procedures

SECTION 2: REPLACEMENT PROCEDURES

Make use of the following tools and supplies for maintaining the printer and

installing the repair kits:

Hand Tools

• #0 or #1 Phillips Head Screw Driver

• A 1/8” Hex Driver or equivalent diameter dowel pin, at least 2” long

Supplies

• Cleaning Pen (10 pack), p/n AN11209-1

• Cleaning Kit with Cleaning Pen, and Cotton Swabs p/n AT702-1

• Isopropyl alcohol

• Media, Batteries, and Chargers for MZ series printers per table below:

Mobile Printer

Model #

3.2 mil Journal

Media (for Life

Test)

Battery

Replacement Kit

Single Charger/

Quad Power

Station

MZ 220 LD-D2KV5E

AK18353-1

AK18355-x/

AK18342-x

MZ 320 LD-D3KV5B

1. Full part number is determined by intended country of use. Contact your re-seller of the factory for complete

information.

TOOLS AND SUPPLIES

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Zebra MZ series Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Zebra MZ series