Zebra R402 Guide de l'utilisateur télécharger pdf (Page 48)

Replacing the Print Head

In the event you need to replace the print

head, make sure your work area is

prepared by protecting against static

discharge. Your work area must be

static-safe and include a properly

grounded conductive cushioned mat to

hold the printer a conductive wrist strap

for yourself.

Removal

Before following the steps in this

procedure, open the printer by pulling the

release latches forward then lifting the top

cover. Remove any ribbon from the

carriage.

1. Grasp the print head spring and pull it

to the left; then, slide it free of the

carriage.

2. Use the spring to pry the print head

clip off the right side of the carriage.

3. Pull the print head and bracket

forward.

4. Use a #2 Phillips driver to remove the

screw that holds the ground wire.

5. Unplug both bundles of print head

wires from their connectors.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 71 72

Pas de commentaire

Zebra R402 Guide de l'utilisateur Page 48