Zebra TLP 3844-Z Guide de l'utilisateur télécharger pdf (Page 27)

Serial Communications (Continued)

^SC Command

Use the Set Communications (

^SC

) command to change the

communications settings on the printer.

1. With the host computer set at the same communications settings as the

printer, send the

^SC

command to change the printer to the desired

settings.

2. Change the host computer settings to match the new printer settings.

Refer to the ZPL II Programming Guide for more information about this

command.

Defaulting the Serial Parameters

To reset the communications parameters on the printer to the factory

defaults (9600 baud, 8 bit word length, no parity, 1 stop bit, and

XON/XOFF), do the following:

1. Press and hold the feed button until the green status LED flashes once,

twice, and then three times.

2. While the status LED rapidly flashes amber and green, press the feed

button.

980441-001 Rev. A 19

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 67 68

Pas de commentaire

Zebra TLP 3844-Z Guide de l'utilisateur Page 27