Zebra TLP 3844-Z Guide de l'utilisateur télécharger pdf (Page 31)

Printing in Peel-Mode

The optional dispenser allows you

to print in “peel-mode” where the

label backing follows a different path and

the labels are presented one at a time for

subsequent placement.

Before using peel-mode, you must send

the programming commands

^XA ^MMP ^XZ

^XA ^JUS ^XZ

to the printer. Refer to your ZPL II

Programmer’s Manual.

1. Remove several labels from the

backing material.

2. Open the top cover.

3. Open the dispenser door.

4. Switch on the label-taken sensor.

5. Insert the backing in front of the peel

bar and behind the peel roller.

6. Close the dispenser door.

7. Close the top cover.

8. Press the Feed button to advance the

label.

During the print job, the printer will peel

off the backing and present a single label.

Take the label from the printer so it will

print the next label.

980441-001 Rev. A 23

ON OFF

MOVIE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

Pas de commentaire

Zebra TLP 3844-Z Guide de l'utilisateur Page 31